Filtro automático horizontal controlado por motor - RFL-RFXL

The filter body is St-37 or stainless-steel optionalityThe filtering in pressured linesHigh performance during the back washingExtensive Filtering SurfaceEasy-to assembly and fitler components, not required to change100% back washing performanceThe back washing time for 50-30 sec.Working opportunity, not required additional energyThe minimum head and water loss.


Body Material: S195T / SS 316L / SS 304 L
Screen Material: SS 304L, PA6GFR30
Maximum Working Pressure: 10 Bar (145 PSI)
Minimum Working Pressure: 1 Bar (15 PSI)
Maximum Working Temperature : 60 °C (140 °F)
Back Flush Operation Criteria: Time and / or Pressure Differential
Back Flush Controlling Unit : Electronic (AC) Control
Filtration Degree: 20-2000 micron (µ)
Painting Method: Electrostratic Powder Coating
Painting Material: Epoxy Polyester

Technical Specification

Inch mm Inch m³/h m³/h cm² Pieces
RFL1810 10 900 909 1410 2465 18 2 18 380 10028 4
RFL1812 12 900 909 1410 2465 18 2 18 480 10028 4
RFL1814 14 900 909 1410 2465 18 2 18 600 10028 4
RFXL1814 14 1000 909 1810 2865 18 2 23 650 14803 6
RFXL1816 16 1000 909 1810 2865 18 2 23 900 14803 6

Working Principle

The water entering the filter passes through the coarse screen and passes to the area where the fine screen filter is located. The water continues to flow from the fine screen to the outlet and creates a layer of pollution on the inner surface of the fine screen and this pollution causes a pressure difference at the inlet and outlet of the filter. The dirty layer on the screen surface causes difficulty on the water flow. This flow difficulty creates a pressure difference between the inlet and outlet. The difference value is detected by the ΔP sensor and transmitted to the control unit to start the washing.

The Control Unit opens the motorized valve. While the motorized valve is discharging the dirty water; the control unit activates the engine. The circular movement of the reducer motor ensures a helical movement on the suction nozzles which are on the collector assembly make. The transmission of the movement is made with a square threaded shaft. The movement of the reducer motor is controlled by optical sensors. Thus, the screen surface is completely scanned and the dirty layer is cleaned. The absorption of the dirty layer is made by the nozzles, as the system that opens to the atmosphere creates a vacuum effect in the filter. The sucked particles pass through the cover body by the collector assembly and are discharged out from the discharge section. The collector set returns to its starting position and continues the washing while returning also. The relief valve is closed and the cleaning process is completed. The filtration process is not interrupted during backwashing.

Formulário de Contato
Çerez Kullanımı
Sitemizin, çalışması için çerezler kullanılmaktadır. Site üzerinde kullanılan çerezler hakkında detaylı bilgi almak için Çerez Politikası’nı incelemenizi rica ederiz.
Anladım Çerez Politikası